Home › Forums › All Things 750 Twin › Projects and Progress › New Projects › Z750B1 1976 › Reply To: Z750B1 1976
Its been a couple of busy weeks and I haven’t had a lot of time for this project but I have decided its time for the rest of the bike to get stripped down.
I have taken the wiring harness off to repair it and done a few small bits and pieces but I want to try and start the motor before stripping the bike down so I can get some idea of its condition. If it runs ok with no knocking or smoking then I shouldn’t need to take it apart. I made up some temporary wiring for the ignition system and oil light and put the carbs pack on. I cleaned the points but I didn’t even look at the ignition timing or check carb float heights or balance. Here is a short video of the result.
I am going to take the rest apart now and start prepping the frame for powdercoating.
More to follow.