Z750 MAN 279X

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #27936
    Piemuncher
    Participant

    Got this last August, it belonged to a bloke who died and it was destined for the skip in his house clearance.

    This is how it started

     

    This is where it is now

    Just rebuilt the rear wheel

    #28015
    Piemuncher
    Participant

    This is my solution to the mainstand pivot which someone had sawn off because it was seized. Made a new pivot shaft out of stainless steel it pivots on the needle roller bearings which are clamped to the frame in the original clamps.

    #28017
    Piemuncher
    Participant

    #28014
    Piemuncher
    Participant

    #28013
    Piemuncher
    Participant

    This is my solution to the mainstand pivot which someone  had sawn off because it was seized. Made a new pivot shaft out of stainless steel. it pivots on the needle roller bearings which are clamped to the frame in the original clamps.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

Share this