Home › Forums › All Things 750 Twin › Projects and Progress › New Projects › B1 Project Started. › Re: Re: B1 Project Started.
20th March 2013 at 7:08 pm
#8781
Tango
Participant
I did learn that Not Only is there a correct way for the Lower Axle clamps to fit to the bike!
(Arrows to the front!)
I also learnt that there was a correct way to tighten the nuts up!
1st the front nuts finger tight until there is NO! gap and then the rears finger tight this should leave a small gap at the rear Only!
Then torq down to correct tension!