Activity

Are these for a B2? I have found the B1 stripes at Diablo but they work out quite expensive. There is a place down Leicester way if I remember correctly. They said they will do them but they need samples to copy. I haven’t had the chance to follow this up yet.

Whereabouts are you?

recieved. thanks

Is that one of the front middle two? They are open to the elements and always cause problems for removing the barrels. I would seriously look at replacing those 2 at least as that is where the head gasket usually fails.

KK

Evening all (anybody out there?)

Did a bit more today, stripped head the valves look nice and straight just need seats grinding when it and the barrels come back from vapour blasting.

It took a full week of nipping in the garage pouring plusgas down the studs and whacking with a big mallet before the barrels came loose the pry points weren’t…[Read more]

That is bad. I also notice it has a copper washer. That should be an O ring. Will add that too.

Yes I will also add a front tensioner and PM you with details again.

Cheers

KK

Afternoon kaptain!

Looking at my tensioner, looks like a better cap would be good idea, this one will leak, can you add one to the order, if not already included, also do you have any serviceable cam chain tensioner guides? The front one on mine looks little worn and couple small bits missing mainly on the outer edge?

Thanks

Karl

Posted

KK

I can supply you with one of these if you are still looking. I have them in stock

KK

Hi KK

Yes , i was thinking of just putting some thin gasket paper behind it the bring it out a bit more or just get two orings

Hi Karl

I have gone through your list and can so far supply everything you asked for. I have added an oil filter and oil filter O ring plus the 2 seals in the sprocket housing for the gear selector shaft.

Most parts I have here but some I will need to order in.

The total cost for everything (inc extra bits suggested) is £237. I am guessing…[Read more]

Thanks Colin 😊

Good luck Karl! That’s quite a challenge.
Cheers,

Colin.

Ok try again and press submit this time!

Can you work out prices for the rings,  gudgeon pin clips (pins not needed), full gasket set, also seals (clutch push rod, gearbox, kicker, points, valve guide, any i missed?)

Also kicker cover, and exhaust clamps. As for camchain tensioner plunger and springs is all need i think? If you don’t want to…[Read more]

Evening kk

I thought I replied to your last message for definite list this afternoon when I got up ( off nights) but cant see it. Did I do it wrong again?

Karl

Do you mean the O ring one shaped like a No 8?

Not sure where to get the weird double oseal from though?

Has anyone just put two normal oseal in there instead? What sizes did you buy?

Hi Karl

Please see below

Full gasket set – I only have top end gasket sets at the moment. They covering everything from the large ‘O’ ring on the bottom of the barrels up except for the valve guide seals. I have got Clutch cover, Points cover, Generator cover, Transmission cover, Clutch adjuster cover and Oil pump gaskets separately and can add…[Read more]