SquadronLeader

Hi All, I have posted things on facebook regarding starter motor issues but for those who dont use it here is what I have found.

My starter was very sluggish so over this winter decided to see if I can find out why, I removed the motor and stripped it down to check it according to the manual, firstly I noticed that the motor before strip down was…[Read more]

I have that on order from KK.

Well it went on its maiden voyage today,  50 mile round trip to the old bus station at Abergavenny, will need the headstock tightening a bit but apart from that all looks good,  stick it in top gear and just keep going.

Well she’s out of the workshop and ready for the test run

Paint nearly done just a small amount left but here’s what the rest looks like

Looks like that bike will go anywhere,

its coming along, but the bad news is now Chrome wont be ready till end of May due to work load in factory, good news is wont be able to do much after next week due to my op, so timing is not too bad..

Added a few more parts but it’s now at a standstill waiting for the chrome,  carbs and paint

yes, good luck with your project, keep the pictures coming.

paul

Added bling, don’t look bad..

We managed to get some bling back yesterday,  polished engine cases and rebuilt wheels in stainless,  have sent original rims to the chromers as they say they can be rescued, installed wiring loom and rear brakes,  will do a couple of more parts today.

Polished by imperial polishers Stourbridge.

well started putting on a few bits on, engine in, waiting for the engine side panels from polishes, and chrome bits, just stripping what’s left of the old lacquer ready for polishing,  powder coating some by TJ wheels in Cradley.

Now waiting for parts from KK which are on their way.