- This forum has 136 topics, 790 replies, and was last updated 3 years, 8 months ago by
.
-
- Topic
- Voices
- Posts
- Last Post
-
- Carbs. My recently acquired KZ b3 starts easily and runs nicely up to 4000 rpm and cruises smoothly at tha…
- 4
- 7
- 10 years, 2 months ago
- Fuel petcock I’ve managed to break the lever on my B3 fuel tap ( used to Honda reserve position) I was thi…
- 3
- 11
- 10 years, 3 months ago
- Carb vents b1 model Quick question on the carbs on my b1 the two vacuum takeoff or vents are connected to each other wi…
- 3
- 4
- 10 years, 3 months ago
- Regulator Rectifier B1/B2 Hi can anybody help. I have been looking at combined regulator rectifiers that may be able to be fi…
- 2
- 2
- 10 years, 5 months ago
- fuel cock for B-models Hi B-Owners, after I had only one fuel cock for a B-tank in bad condition and that one was modified…
- 2
- 9
- 10 years, 5 months ago
- Valve Lifter Holder – will this fit? Hi, Hans from Sweden here and I own a KZ 750 twin 1976. When adjusting the valves there was a speci… 1 2
- 4
- 29
- 10 years, 6 months ago
- Gasket Sealant I’m doing a top end rebuild on my CSR. Barrels and head. Should I use any sealant on the gask…
- 2
- 3
- 10 years, 6 months ago
- Oversize pistons and rings now available ! Hi Lonesome Twins, a well known and well reputated engine parts company in Germany is now offering …
- 2
- 2
- 10 years, 7 months ago
- Float height setting Hi Guys Is there a “good” way of setting the float heights on the B model carbs? The bi…
- 5
- 10
- 10 years, 10 months ago
- Center stand for LTD K1 Belt Drive Hi guys, I have the bike in my garage, took some pics and made some measurements. The gap between t…
- 1
- 1
- 10 years, 10 months ago
- Engine out Hi Guys (and Gals)Started to strip the KZ to get the frame coated,I seem to think I have to remove …
- 4
- 7
- 11 years ago
- feed back info please ok got a z750 twin it was KK and hoggys and beefs once upon a time our lass’s bike now stripp…
- 2
- 3
- 11 years, 1 month ago
- Wiring Loom / Harness and engine strip Evening folks, Not been on for a good while but I’m the one with the Brat Scrambler style KZ7…
- 3
- 4
- 11 years, 4 months ago
- timing went to set the timing today… new points etc,, highlighted the marks.. just cant get it spot …
- 4
- 7
- 11 years, 4 months ago
- Setting up carbs Could any one help in advising me with what the initial set up for the butterfly valves are please.
- 2
- 7
- 11 years, 6 months ago
- You must be logged in to create new topics.
